Use consistent units of measurement (inches, feet, mm, cm, etc.) in this form. Do not enter units (in, mm, etc.) into form, only enter numerical values as noted in examples to right of each text entry box.Taper Major Diameter: large diameter of taper - example: 6Taper Minor Diameter: small diameter of taper - example: 2Taper Length: length on Z axis of taper - example: 6Depth of Cut: depth of cut for each pass on Z axis - example: .025Z Offset: this is how much material you want left after each cut - example: .005 This site, all inclusive, is ©2016-2024 Turn and Burn Metalworks, LLC, a Florida Limited Liability Corporation. [ 2024-12-12 12:56:04 UTC ] [ 13107 ]
This site, all inclusive, is ©2016-2024 Turn and Burn Metalworks, LLC, a Florida Limited Liability Corporation. [ 2024-12-12 12:56:04 UTC ] [ 13107 ]