Do not enter units (in/mm) with values into the form, only enter numerical values as noted in examples to right of each text entry box.
Sine bar length:
inches    mm
Angle (degrees):
 (whole or decimal degrees)
Angle (minutes):
 (ignored if using decimal degrees)
Angle (seconds):
 (ignored if using decimal degrees)
Gage block height:
inches    mm (ignored if angle is specified)
 








This site, all inclusive, is ©2016-2026 Turn and Burn Metalworks, LLC,
a Florida Limited Liability Corporation.

[ 2026-06-26 07:48:39 UTC ]

[ 50858 ]